Amico ice 30m, Инструкция по установке и эксплуатации

Страница: 30 / 57

30 Amico Clinical Solutions Corp.
!
CAUTION -
Installation and removal for service or inspection must be carried out by a hospital technician or a
person with similar qualifications who has been trained by Amico Clinical Solutions Corp.
• Never perform an installation or removal of the LED light alone. Always have a second person to assist with the
installation or removal.
• Always disconnect the spring arm system from the power supply when installing or removing the LED light.
Failure to do so may result in electric shock.
• Always make sure the spring arm is at the highest position when removing the light. Failure to do so will cause
the spring arm to spring upwards, and may cause serious injury.
• The LED light may separate from the spring arm if the key is not properly in place. This may cause serious injury.
Always make sure that the key is installed properly.
• Failure to comply with load specifications may cause serious or fatal injuries. Ensure that the LED light load is
within the specifications.
Installation: Amico iCE 30m LED Light
Normal System/LCH
1. Open the front section of the cover using the 2 x M3
screws located as shown in image. Following this slide the
cover to access the mounting spot for the surgical light.
2. Locate 3 x M6 set screws that are currently installed at the
front end piece as shown in image. Loosen these M6 set
screws so that they will not interfere with the mounting of
the yoke. These will be needed for the next step.
3. Install the light yoke to this section. Ensuring the flat
portion of the yoke is in contact with the flat portion of
the Spring Arm.
Note: Light will not have plastic bushings**