Amico ice 30m, Инструкция по установке и эксплуатации

Страница: 27 / 57

www.amico.com 27
Installation: Spring Arms
1. Place the tooth washer on top of the two spacer shims.
Insert the tooth into the hole located in the back of the rear
weld tube and slide the tooth washer over the lip until it
sits around the rear weld tube.
2. Lock the Spring Arm in place using a retaining ring. Make
sure that the retaining ring sits fully in the groove cut out.
• For Oasys Spring Arms, use provided thick spacer.
Tooth washer and 2x snap rings.
• Ensure Spring Arm is positioned correctly.
Pull down if necessarry.
3. Remount the pole tab using the two 6-8 screws on either
side of the adaptor weld. Ensure friction screws are put
back and screwed in all the way.
4. Clip the front plastic cover pieces together and secure
them in place using two M4-6 screws on either side.
5. Replace the plastic cover caps by pressing inwards and
turning. Ensure that any labeling is positioned right side up.