Amico ice 30m, Инструкция по установке и эксплуатации

Страница: 20 / 57

20 Amico Clinical Solutions Corp.
1. Insert an M10 rod into the six smaller outer holes in
anchor plates using a M10 nut on either side of the
bottom anchor plate to keep them from moving up
and down. Be sure to mount the M10 rods at roughly
the same height to keep the square ceiling covers
level.
Note:
Threaded holes in the M10 rod should face
downwards.
Note:
Collar must clamp under ceiling covers.
2. Install using the 2 x ¼-20 button head screws with a
¼" washer as shown in the image.
1. Raise the extension arm assembly and insert the
Central Axis coupler into the shaft of the Central Axis
drop tube housing. Match the six holes on both the
Central Axis coupler and the Central Axis drop tube
housing, and put in the 6x 1/4-20 button head screws
with a ¼" washer to keep it in place. This step will be
the same for both the Series One and Series Three
center tubes.
For the Series Three side mounts, use 2x ¼-20 button
head screws with the ¼" washers to keep it in place
on the sides, and 4x ¼-20 socket cap screws on the
front and back holes with the deeper counter sinks.
If there is a monitor arm on the center axis, set up the
up the stoppers in the correct orientation so that once
installed, the range of motion is as desired.
Installation: The Central Axis
Amico Ceiling Covers - Square Ceiling Covers Option for Both Series One and Series Three
Installing the Central Axis