AMERITECH AM8a, Инструкция по эксплуатации

Страница: 54 / 152

AM8a Instruction Manual (18-0037) Emulation Parameters
0037-S03.L_24 February 10, 2000
3-7
3.13 START TIME EMULATE
These parameters are used for programming the timing of the
DELAY
and
WINK START
SIGNALS
.
START TIME:
EMULATE : DLY:BGN/ENDms
100 250
WINK:BGN/DURms
100 250
BGN = 15 to 999 (1ms steps)
END = 100 to 9999 (1ms steps)
BGN = 15 to 999 (1ms steps)
DUR = 50 to 999 (1ms steps)
Alternate:
3.13.1
DLY:BGN/ENDms:
This setting controls the
DeLaY BeGiN
timing. This is the time from
seizure until the
DELAY START DIAL
signal is sent. The AM8a must be set to
EMULATE
and have the
AUTOMATIC
selection made. The
END
time is when the
DeLaY
signal will be removed.
3.13.2
WINK:BGN/DURms:
This setting controls the wink
BeGiN
timing. This is the time
from seizure until the
WINK
is sent. The AM8a must be set to
EMULATE
and have the
AUTOMATIC
selection made. The
DUR
ation controls how long the wink is on the line.
3.14 SF EMULATE
This menu sets the level and frequency variation of the Single-Frequency (2600Hz) signal that
is used for signaling when the
TRUNK TYPE
is
SF
(Refer to 2.4.1).
SF
EMULATE : LEVELdBm
–10
–40 to 0
(1 dBm steps)
Alternate:
:
FREQ + %hz
0.0
-2 to 2
(.1 % steps)
3.14.1
LEVEL:
sets the 2600Hz
SF
tone from –40 dBm to 0 dBm.
3.14.2
FREQ+%hz:
sets the frequency variation of the 2600Hz
SF
tone from –2% to +2% in
.1 % steps (2548Hz through 2652Hz).