AMERITECH AM8a, Инструкция по эксплуатации

Страница: 57 / 152

Analysis Parameters (18-0037) AM8a Instruction Manual
February 10, 2000 0037-S04.L_
4-2
4.2 STRT SIG (START SIGNAL) ANALYZE: EXPECTED TYPE
This menu is used to set the Start Signal
EXPECTED
by the AM8a when it is the calling party
(originator of the call). Dialtone will always be accepted, and the additional choices that can
be recognized are either wink or delay start.
STRT SIG :
ANALYZE: EXPECTED TYPE
dialtone/wink
dialtone/delay Alternate:
4.2.1
dialtone/wink:
This instructs the AM8a to
EXPECT
dialtone OR a wink as the Start
Dial. If a wink is received in less than 999 ms, the Events display will show a "
W
". If
the wink is not received within 999 ms, the Events display will show a "
Pp
". Within
the 999 ms, error reporting will depend on the parameters in the
WINK STRT
menu.
4.2.2
dialtone/delay:
This instructs the AM8a to
EXPECT
dialtone OR a delay dial signal.
When the delay dial signal is received, the Events display will show a "
Pp
". Error
reporting will depend on the parameters in the
DLY STRT
menu.
4.2.3
dialtone/...:
Dialtone will always be accepted as a start signal. If a dialtone is received,
an "
X
" will be displayed and error reporting will depend on the parameters in the
DT
STRT
menu.
4.3 DT STRT (DIALTONE START) ANALYZE: DIALTONE RCVDms (min/max)
This menu selects the
DIALTONE RECEIVE
timing. If dialtone is received as a Start Signal, it
must arrive within this threshold to be valid. If received outside of these limits, it will be
flagged as an error.
DT STRT :
ANALYZE:
DIALTONE RCVDms(min/max)
0 3000
0 to 9999 (1ms steps) Alternate: