AMERITECH AM8a, Инструкция по эксплуатации

Страница: 92 / 152

AM8a Instruction Manual (18-0037) RS232 Entries and Printouts
0037-S07.L_58 February 10, 2000
7-3
7.1.3.1
Display Menu:
To display a menu, type a command that corresponds to any
parameter within that menu. The menu will then be displayed on the AM8a. For
example: (
CTD
) or (
CEM
) displays the
MODE CONFIGURE
menu.
7.1.3.2
Change Parameter:
To change a parameter, find the command that sets the
parameter within a menu. Type the command then an equal "=" sign. After the
equal sign there are two kinds of values that can be entered, followed by the closing
")".
•
A Code Value: This is a code from 00 through 07 (leading "0" may be omitted).
Each code corresponds to a parameter setting that is not numeric, for example
(refer to Figure 7-3):
(CTD=00)
or
(CTD=0)
sets
MODE CONFIG: IMITATE
to te/line
(CTC=02)
or
(CTC=2)
sets
PCM: FRAMING
to
SLC®96
•
A Numeric Value: This is an entry that directly sets a numeric value into the
parameter, for example:
(CSM=1200)
sets the
CIRCUIT: ANALOG IMPEDANCE
to 1200 ohms
7.1.3.3
Print Menu:
If not already displayed, the menu with the changed parameter must be
displayed by a (
PDS
) command. For example, if the
DISPLAY CONFIG
menu
containing
CONTRAST
was not displayed when the (
CCT=3
) command was
entered, type (
CCT
). To print the displayed menu, follow with (
PDS
), and the menu
will be printed, showing the parameter value that has been entered:
DISPLAY: MODE CONTRAST BACKLIGHT
CONFIG: new call reset 3 on 5min
7.1.4
AUTO DIAL Setup Commands:
The
AUTO DIAL
Setup key on the front panel permits the
operator to enter up to 10 sequences of auto dialing (also referred to as "Speed Dial").
Details on
AUTO DIAL
are provided in Section 5. The
RS232
equivalents for setting,
storing, recalling, and dialing
AUTO DIAL
numbers are shown in Figure 7-6. Also
shown are other commands related to dialing as well as the equivalent characters that
are typed for the Data Entry keys for dialed digits (and other dialing sequence
operations).