AMERITECH AM8a, Инструкция по эксплуатации

Страница: 42 / 152

AM8a Instruction Manual (18-0037) Configuration Parameters
0037-S02.L_22 February 10, 2000
2-7
2.5 DISPLAY CONFIG 1 AND CONFIG 2
These menus control the AM8a LCD display and equivalent printouts. They allow the user to
set the display to respond to calls, dialing events,
SLC®
messages, and single-tone events.
DISPLAY:
CONFIG1 :
Alternate:
MODE
new call reset
manual reset
scroll
DIG DET
narrow
wide
limit
SLC
®
MSG
0000000001
0000000000 to
1111111111
DISPLAY:
CONFIG2 :
Alternate:
T/t MASK
NO
YES
2.5.1
MODE:
This parameter controls how the events display will be updated.
new call reset:
This selection will reset the display each time a new call is encountered.
Events will enter the display buffer until it is full (80 characters max). After it is full,
further events will be ignored until a new call is encountered.
NOTE:
40 characters will be displayed on the screen, while the remaining 40
characters are kept in the buffer until selected for viewing via the keys.
manual reset:
This selection will display events until the 80 character buffer is full.
All events after this will be ignored until the display is cleared by pressing the [
SHIFT
]
[
CANCEL
] keys.
NOTE:
In monitor mode for
PCM
, with channel number of 0 (random select)
specified, the [
SHIFT
][
CANCEL
] keys will immediately abort monitoring of
the current call so that the AM8a can monitor the next new call.
scroll:
This selection will allow the most recent 80 events to be displayed as they
occur. Old events will scroll off the display and be discarded as new events replace
them. The
FREEZE
function is useful here to "stop" the display to analyze specific
events.