AMERITECH AM8a, Инструкция по эксплуатации

Страница: 25 / 152

Front Panel Operation (18-0037) AM8a Instruction Manual
February 10, 2000 0037-S01.L_
1-8
1.3 SETUP AREA
The Setup area on the front panel controls the programming of the AM8a unit for all test
procedures. It is here that required parameters are set for configuration, emulation, analysis
and auto dialing functions. Each of these areas are briefly described below, and specific
information on all the parameters that are available in each Setup category is shown in Section
2, 3, 4, and 5.
1.3.1
CONFIG'N ([SHIFT][5]) Key:
When selected, the menus identified by "
CONFIG
" are
presented. All the parameters for basic configuring of the line can be set in this mode
(software version is also shown). Settings include:
•
Whether the AM8a is to be used as a switch (CO) or terminal/line.
•
Which trunk type is being monitored or emulated.
•
Time and date.
•
RS232 baud rate, parity, and CR delay.
•
Flags for SLC®96 display options.
•
Manual or new-call display reset.
1.3.2
EMULATE ([SHIFT][6]) Key:
When selected, the menus identified by "
EMULATE
" are
presented. This mode allows access to parameters that control timing of AM8a
generated events. Settings for voltage, frequency and timing are to be made here, as
well as for impedance, ringing voltage, dial tone and dial pulse, recall (flash and
unbalance), and tone dialing.
1.3.3
ANALYZE ([SHIFT][7]) Key:
When selected, the menus identified by "
ANALYZE
" are
selected. These parameters are used to instruct the AM8a on how to interpret events
the events it encounters. It is also used to set thresholds for flagging and printing
errors or flaws in a call sequence.
1.3.4
AUTO DIAL ([SHIFT][8]) Key:
When selected, the dialed number display is presented.
Stored dialing sequences which can be automatically recalled are set in this display.
Up to 11 dialed sequences can be stored in Auto Dial. Each sequence can contain up to
60 characters. This display is shown in Section 5.