American Megatrends Olympus III, Руководство пользователя

Страница: 51 / 146

Chapter Two : Hardware Installation 41
Step 5 Attach Internal Cables,
Continued
J7 is a 40-pin dual-inline berg that connects an IDE drive to the primary onboard IDE
connector. This motherboard supports the following:
Data Transfer Rate
(max.)
Cable Conductors CRC
DMA Mode 1 11.1 MBs 40-pin IDE 40-pin no
Multi-word DMA
Mode 1 13.3 MBs 40-pin IDE 40-pin no
Multi-word DMA
Mode 2 16.6 MBs 40-pin IDE 40-pin no
Ultra ATA Mode 2
ATA-33 33.3 MBs 40-pin IDE 40-pin yes
Ultra ATA Mode 4
ATA-66 66.6 MBs 40-pin IDE 80-pin yes
Ultra ATA Mode 4
ATA-100 99.9 MBs 40-pin IDE 80-pin yes
Ultra ATA Mode 4
ATA-133 133.3 MBs 40-pin IDE 80-pin yes
These IDE features can be configured in the AMIBIOS Setup utility from the
IDE
Configurations submenu in the Advanced section.
The IDE cable that is included with the Olympus III motherboard is a color-coded, 80
conductor/40 pin, ATA-100/133 IDE cable. Connect the blue connector to J7 and the
black connector to the primary master IDE device. The white connector is reserved for
the primary slave IDE device.
Ultra ATA-100/133
The Olympus III motherboard supports Ultra DMA-100/133. In order to take advantage
of this feature, you must have the following:
•
DMA-aware operating system
•
Ultra ATA-100/133 compatible IDE device
•
40-pin 80-conductor cable (included)
Note: Some IDE devices that are ATA-33 (and lower) cannot be used with the Ultra ATA-
100/133 cable. This is very rare. If the device is not recognized, you must use a standard
IDE cable. The Olympus III motherboard does not include a standard IDE cable.
Cont’d