AMCI SD17060E2, Руководство пользователя

Страница: 121 / 144

20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786

Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
121
TASK 4 (EtherNet/IP Option)
I
MPLICIT
C
OMMUNICATIONS
W
ITHOUT
EDS
4.1 Host System Configuration
RSLogix 5000 is used to configure both the ControlLogix and CompactLogix platforms. When using these plat-
forms, you have the option of using a separate Ethernet Bridge module or an Ethernet port built into the processor.
If the Ethernet port is built into processor, the only step you have to take before adding the SD17060E2 or
SD31045E2 is to create a new project with the correct processor or modify an existing project. Once this is done,
the Ethernet port will automatically appear in the Project Tree. If you are using an Ethernet bridge module, you
will have to add it to the I/O Configuration tree before adding the driver to your project.
Refer to your Rockwell Automation documentation if you need instructions for configuring the ethernet port.
4.2 Adding the SD17060E2 or SD31045E2
You can add the Networked Driver to the project once the Ethernet port (built-in or bridge module) is configured.
1) Right click on the Ethernet port and then click on “New Module...” in the pop-up menu.
Figure T4.1 Adding an AMCI Networked Driver
Each AMCI Networked Stepper Driver requires a host controller to issue configu-
ration and motion commands to it. This chapter tells you how to configure implicit
connections in EtherNet/IP systems that do not use EDS files. If you instead wish
to use explicit messaging, refer to the next chapter for information on using mes-
sage instructions.
Rockwell Automation’s RSLogix 5000 version 20 software is used for the example
installation in this chapter.