Amazone KE 2501 Special, Руководство по эксплуатации

Страница: 30 / 174

General Safety Instructions
30 KE/KX/KG (RIGID) BAH0089-7 02.2020
2.16.4 Electrical system

When working on the electrical system, always disconnect the
battery (negative terminal).

Only use the prescribed fuses. If fuses are used that are too
highly rated, the electrical system will be destroyed – risk of fire

Ensure that the battery is connected correctly – connect the
positive terminal first and then connect the negative terminal!
When disconnecting the battery, disconnect the negative termi-
nal first, followed by the positive terminal.

Always place the appropriate cover over the positive battery termi-
nal. If there is accidental earth contact, there is a risk of explosion

Risk of explosion: avoid the production of sparks or the presence
of naked flames in the vicinity of the battery.

The implement may be equipped with electronic components
whose function is influenced by electromagnetic interference
from other units. Such interference can pose risks to people, if
the following safety information is not observed.

In the case of retrofitting electrical units and/or components
on the implement, with a connection to the on-board power
supply, the operator is responsible for checking whether the
installation might cause faults on the vehicle electronics or
other components.

Ensure that the retrofitted electrical and electronic compo-
nents comply with the EMC Directive in the appropriate
version and carry the CE mark.
2.16.5 PTO shaft operation

Use only the universal joint shafts prescribed by the AMA-
ZONEN-WERKE factories, equipped with the proper safety de-
vices.

Also read and follow the operating manual from the universal
joint shaft manufacturer.

The protective tube and universal joint shaft guard must be un-
damaged, and the shield of the tractor and implement PTO shaft
must be attached and be in proper working condition.

Work is prohibited while the safety devices are damaged.

You can attach and detach the universal joint shaft only when

the PTO shaft is switched off.

the tractor engine is switched off.

the parking brake has been applied.

the ignition key has been removed.

Always ensure that the universal joint shaft is installed and se-
cured correctly.

When using wide-angle universal joint shafts, always install the
wide angle joint at the pivot point between the tractor and im-
plement.

Secure the universal joint shaft guard by attaching the chain(s)
to prevent movement.

Observe the prescribed pipe overlaps for universal joint shafts in
transport and working positions. (Read and follow the operating
manual from the universal joint shaft manufacturer.)