Amazone KE 2501 Special, Руководство по эксплуатации

Страница: 150 / 174

Cleaning, maintenance and repair
150 KE/KX/KG (RIGID) BAH0089-7 02.2020
1. Loosen the fastening nuts (Fig. 168/1).
2. Replace the worn coulters or adjust the
coulters for the operating conditions.
3. Tighten the fastening nuts (Fig. 168/1).
When changing the coulter, observe:

Mount the coulter parallel to the tool carrier
without a gap.

After 5 hours of use, check the bolt connec-
tion for tight fit.
Fig. 168
The pulling force requirement depends
in the tools used.
Tool
Pulling force re-
quirement
Wing coulter (Fig. 168/4) large
Heart-shaped coulter (Fig.
168/2)
Narrow coulter (Fig. 168/3) Small
Fig. 169
12.4.2 Replacing the tension springs of the overload safety device (workshop work)
CAUTION
The overload safety on the tines consists of tension springs that are
under high pretension. It is essential to use appropriate tools to install
and remove the tension sprin You must use the suitable device to
install and remove the tension springs in all cases.
Otherwise, there is a risk of injury.
Additional information via Customer Service / Dealers.
12.5 Lubrication specifications
Carefully clean the grease nipple and grease gun before lubrication so
that no dirt is pressed into the bearings. Press the dirty grease com-
pletely into the bearings and replace it with new grease.