Amano EM-e II, Руководство по эксплуатации, Страница: 28 / 56

２７
4.Operation
(continue)
Be sure to read and understand on the page 3 to 7 “For safety operation” carefully before use
External operation setting
Important
● About the type of external operation ：
This machine can be operated by continuous signal and the one-shot signal. If interlock signal is operated, operates
when closing the contact and stops when opening the contact. During the one-shot signal, once the contact is closed,
the circuit is changed inside the machine. It need not continuing the contact closed. Input one-shot signal again to stop
the machine.
●
Please input the one-shot signal over 500ms(0.5s).
Except the operation by control panel; this machine can be operated by external signal of machine tool or switch
installed specially. The operation is called “external operation” in this manual. By the setting, select the type of signal for
external operation. During operation, it is only displayed and the setting cannot be changed.
Be sure to stop the operation before setting.
●
1
Changing the mode setting
Press
△
or
▽
switch to make
⑦
appear in the top right corner in the
mode setting display.
●
2
Making flash the top-right icon “
⑦
”
Press the SET switch to blink
⑦
of the top right corner.
●
3
Changing the setting
During blinks of
⑦
, press
△
or
▽
switch to appear n-04 on the
display. Then, press the SET switch to appear
『
000
』
in display. After
the setting, press the SET switch. At the time of registration, the
buzzer sounds.
000
・・・
Manual
(Default)
001
・・・
Interlock 002
・・・
one-shot
●
4
Back to the top
Press the ESC switch to back the display condition as suggested in
the right.
Be sure to press the SET switch during blinks of the icons in
display. At the time of registration, the buzzer sounds and the
setting become effective. If you forget to press the SET switch
or the buzzer does not sound, the setting is not changed.
Caution