Amada 1000ADP, Руководство по эксплуатации

Страница: 88 / 112

APPENDIX D: COMMUNICATIONS
125ADP/300ADP/1000ADP DUAL PULSE RESISTANCE WELDING POWER SUPPLY
D-6 990-922
STATUS
”TS” Read Status of unit or the last weld. 2 Bytes
0 = GOOD.
1 = Capacitors did not discharge in 15 seconds.
2 = Capacitor does not charge in time.
3 = Firing switch does not close within 10 seconds of FS2 closing.
4 = The capacitor calibration value is outside of limits.
5 = Internal EEPROM memory error.
6 = Internal EEPROM values corrupted. Default values loaded.
7 = Power board fuse blown.
8 = Communication error between control board and front panel.
9 = Exiting Edit mode.
10 = Emergency Stop (EMO) input is open.
11 = Invalid Chaining start or end value.
12 = Last Weld was out of Limits.
SYSTEM
“YS” Set <ACK OR NAK> 1 Byte
SYSTEM “YR”
Read BAUD RATE (rate) 1 Byte
DEBOUNCE (0=None, 1=30ms) 1 Byte
BUZZER (0=Off, 1, 2, 3, 4=loud) 1 Byte
FAST WELDING (0=Off, 1= On) 1 Byte
REMOTE (0=Off, 1= On) 1 Byte
CHAINING START, (0=Off, 01-63) 2 Bytes
CHAINING END (0=Off, 01-63) 2 Bytes
9 Bytes Total
-------------------------------------------------------------------------
rate 0=9600, 1=19.2 k, 2=38.4 k Baud