Full Height Tandem Installation Instructions
Page 16 [email protected] +1(909) 591-8431 www.alvaradomfg.com
Installation Instructions
Final Mechanical Installation Steps
Fig. 23
Drill
9/64" Drill Bit
#10 x ¾" Phillips
pan head screw
Screwdriver
NOTE
Be sure that the turnstile is level
before performing the following step(s).
1.
The anchor bolts (22 total) and the Top
Channel mounting bolts should be tightened to
40 ft-lbs using a torque wrench and appropriate
sockets.
2.
Using a drill and 9/64" drill bit, pre-drill six holes
through the guard plate and into the Yoke (three
along each side of the Yoke).
3.
Insert and tighten six #10 x ¾" Phillips pan head
screws (Figure 23).
4.
Test the Roto for binding when it is functional. If
there is binding, loosen the mounting hardware and
adjust as needed.
5.
Test the Roto for binding. If no binding occurs,
retighten all mounting hardware.
6.
Repeat all previous steps for the second Guard
Plate installation.
Key turned
90°
Roto
Top
Channel
Guard
Plate
Fig. 24
NOTE
When shipped, the keys are attached to the chassis on the
inside of the top channel.
The key override switch manually unlocks the turnstile in the
desired direction. Key override switches are installed in the
Top Channel, on either side of the Roto.
To engage the key override, turn the key 90°.
NOTE
Remove keys when complete and store in a safe location.
If the key override lock will not properly engage, please refer
to the 'Troubleshooting' section.
This completes your installation
of the MST.
If the MST is electrically controlled,
please proceed to the "Electrical
Wiring Instructions" section.
Key
Key Override Operation
Non-Override
Override
NOTE
The key will always be parallel to the Top Channel in
the override position. The key will always be
perpendicular to the Top Channel in the non-override
position.
Mounting Hole
Mounting Screw
Fig. 23A
23A Inset
Guard Plate Edge
¼-20 x 1" Screw
9/64" Drill Bit
CPST-T and CLST-T Installations
1.
With the guard plate in place, use a pencil
and mark each screw location. Each location
should line up with the upper mounting
channel mounting screw (Appendix A - A9),
3/4" from the edge of the guard plate.
2.
Using a drill and 9/64" drill bit, pre-drill four
holes (two for each side of the Yoke).
3.
Insert and tighten four #10 x ¾" Phillips pan
head screws (Figure 23A inset).