Allworx PowerFlex P810, Руководство пользователя

Страница: 206 / 236

PowerFlex
8/24/48 Port GbE PoE Managed Switch User’s Guide
5.8 Access Management
This section enables configuring access management on the switch including HTTP/HTTPS, SNMP,
and TELNET/SSH. Users can manage the Switch over an Ethernet LAN, or over the Internet.
5.8.1 Configuration
This section enables configuring access management table of the Switch. Sixteen is the maximum
entry number. If the application's type matches any one of the access management entries, it enables
access to the switch.
To configure Access Management via the web interface:
1. Navigate to Security > Access Management > Configuration .
2. Select Enabled mode to enable global access management on the switch.
3. Click
Add new entry
, and then specify the Start IP Address, End IP Address.
4. Check Access Management method(s) (HTTP/HTTPS, SNMP, and TELNET/SSH) in the entry.
5. Click Apply or click Reset to cancel changes and revert to previously saved values. 0.
Figure 135: Access Management Configuration
Parameter Description
Mode Indicates the access management mode operation. Possible modes are:
Enabled : Enable access management mode operation.
Disabled : Disable access management mode operation.
Delete Check to delete the entry. It will be deleted during the next save.
Start IP address Indicates the start IP address for the access management entry.
End IP address Indicates the end IP address for the access management entry.
HTTP/HTTPS Indicates that the host can access the switch via HTTP/HTTPS interface if the host
IP address falls in the IP address range provided in the entry.
SNMP Indicates that the host can access the switch via SNMP interface if the host IP
address falls in the IP address range provided in the entry.
TELNET/SSH Indicates that the host can access the switch via TELNET/SSH interface if the host
IP address falls in the IP address range provided in the entry.
Toll Free 1-866- ALLWORX • 585 -421- 3850 • www.allworx.com
Revised: October 30, 2013
Page 198