Allworx PowerFlex P810, Руководство пользователя

Страница: 106 / 236

PowerFlex
8/24/48 Port GbE PoE Managed Switch User’s Guide
4.10
PoE
Use Power over Ethernet to transmit electrical power to remote devices over standard Ethernet cable.
For example, use it for powering IP telephones, wireless LAN access points and other equipment,
where it would be difficult or expensive to connect the equipment to an external power supply.
4.10.1
Configuration
This page enables the user to inspect and configure the current PoE port settings.
To configure Power over Ethernet via the web interface:
1. Navigate to Configuration > PoE > Configuration .
2. Enable/disable PoE mode for each port using the drop-down menu. Specify the priority and maximum
power.
3. Click Apply or click Reset to cancel changes and revert to previously saved values. 0.
Figure 66: Power over Ethernet Configuration
Parameter Description
Power Supply Configuration
Primary Power Supply [W] The switch can have PoE power supplies. It is used as power source. For being
able to determine the amount of power the powered device may use, the amount
of power the power sources can deliver must be defined.
Ethernet Port Configuration
Port This is the logical port number for this row.
PoE Mode The PoE Mode represents the PoE operating mode for the port.
Disabled: PoE disabled for the port.
Enabled : Enables PoE IEEE 802.3af/at.
Priority The Priority represents the port’s priority. There are three levels of power priority
- Low, High and Critical.
The priority is used in the case where the remote devices require more power
Toll Free 1-866- ALLWORX • 585 -421- 3850 • www.allworx.com
Revised: October 30, 2013
Page 98