Alliance Laundry Systems UY350 PROFORM TOUCH, Установка, эксплуатация и обслуживание

Страница: 37 / 63

Connecting Hoses
To comply with Australian water regulations and Australian
standard AS/NZS3500.1, an approved dual check valve backflow
prevention device with the watermark is provided with the unit
and must be fitted at the point of connection(s) between the sup-
ply and the fitting. Refer to
Figure 28 .
CZB92N
Figure 27
Connections should be supplied by a hot and a cold water line per
national and local codes and in accordance with AS/NZS 3500.1.
1. Insert rubber washers and filter screens (from accessories
bag) in water fill hose couplings (two hoses supplied with
washer). The filter screen must be facing outward.
NOTE: If using hoses with BSPP thread coupling, in-
sert filter screens into the BLACK colored hose cou-
plings and the rubber washers into the brass col-
ored hose couplings.
2. Connect fill hose couplings with filter screens to water supply
taps.
3. Connect the other hose couplings to the hot and cold valve
connections at the rear of the washer.
NOTE: If using hoses with BSPP thread coupling,
connect the BLACK colored hose coupling end of
the fill hoses (with filter screens) to the water supply
taps. Then connect end of hoses with the brass col-
ored hose couplings to the hot and cold water mix-
ing valve connections at rear of washer.
4. Thread hose couplings onto valve connections finger tight.
Then turn 1/4 turn with pliers.
IMPORTANT: DO NOT cross thread or overtighten
couplings. This will cause them to leak.
5. Turn water on and check for leaks.
6. If leaks are found, retighten the hose couplings.
7. Continue tightening and rechecking until no leaks are found.
FLW2216N_SVG
HOT
COLD
7
6
5
4
3
2
1
1. Tap
2. Fill Hoses
3. Install this end of hose to valve connections at rear of
washer
4. Plain Rubber Washer
5. Install this end of hose to water supply tab (Black colored
coupling for BSPP thread)
6. Filter Screens
7. Dual Check Valves
Figure 28
Bath Sample Tap
WARNING
Be careful when taking the bath sample to avoid inju-
ries. Hot water can cause burns.
C376
1. Before taking the bath sample check the water level in the
drum. For correct water level refer to Programming Manual.
2. Let out/drain 0.53 gal. [2 l] of water. For the location of the
bath sample tap refer to Figure 3 .
3. Take the bath sample only while the drum is not turning and
the water is cold.
4. Close the bath sample tap.
Electrical Installation Requirements
IMPORTANT: Electrical ratings are subject to change.
Refer to serial plate for electrical ratings information
specific to your machine.
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
37 Part No. D2601EN