Alliance Laundry Systems UY350 PROFORM TOUCH, Установка, эксплуатация и обслуживание

Страница: 58 / 63

is necessary to keep the distance (A) of 1.3 in. [49 mm] be-
tween the limiter and the vibration switch.
3. To center the switch control element in the rubber bushing of
the limiter, move the holder with the switch left or right.
4. Verify the function is working properly:
a. Remove the right top panel cover.
b. Start extraction mode.
c. After reaching the maximum RPM, carefully switch over
the vibration switch by moving the flexible control ele-
ment manually.
WARNING
Do this carefully to avoid injuries by vibrating
and fixed parts of the machine. After you have
checked the function, mount all panel covers
back to their original places.
C208
Door Seal Thrust
If there is a water leakage around the door, it is necessary to find
out if the problem has been caused due to the door shift out of its
position or if the door seal thrust should be adjusted. In some ca-
ses, the door seal has to be replaced.
Adjusting on the Side of the Door Handle
1. Unscrew the bolt, refer to Figure 46 (detail view "B"),secur-
ing the casing of the door handle.
2. Unscrew the casing from the door bearer always by a whole
turn so that the groove in the casing thread appears below the
securing bolt.
3. To make the casing turn easier, use the semicircle notches to
insert a bolt between the casing and the handle pin. By turn-
ing the handle, the casing will also move.
4. After the door thrust has been adjusted, tighten up the secur-
ing bolt to the groove in the casing thread.
35 - 60 kg / 350 - 600 L Models
7
9
3
CZW23N
1
2
4 5
7
6
8
1. Handle bolt
2. Handle sleeve
3. Frame door
4. Semicircle cuts
5. Handle pin
6. Hinge bolt
7. Hinge
8. Elimination washer
9. Door
Figure 46
Adjusting on the Side of the Door Hinge
If the adjustment at the door handle side is insufficient, it is nec-
essary to perform adjustment at the door hinge side.
1. Loosen two bolts fastening the top door hinge. Refer to Fig-
ure 46 (detail view "C").
2. Take off the elimination washer.
3. Tighten the two bolts fastening the top door hinge.
4. Repeat steps with the bottom door hinge.
5. Check to make sure the door hinge does not move while
opening and closing the door.
6. If the thrust adjusting has not been sufficient, replace the door
seal.
Spring Unit
35 - 60 kg / 350 - 600 L Models
Spring units are to be adjusted if the suspended machine part is
not in a horizontal position (without linen and water) or after the
spring unit has been replaced.
Maintenance
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
58 Part No. D2601EN