Alliance Laundry Systems UY350 PROFORM TOUCH, Установка, эксплуатация и обслуживание

Страница: 35 / 63

Drain Channel-pipe
CZ N W103
1
A B C
2
1. Vent
2. Flow
Figure 24
Water Connection Requirements
WARNING
To prevent personal injury, avoid contact with inlet
water temperatures higher than 125° Fahrenheit [51°
Celsius] and hot surfaces.
W748
The maximum water inlet temperature for vended models is
151°F [66°C]and the maximum water inlet temperature for on-
premises models is 194°F [90°C] (models without WRAS appro-
val) or 140°F [60°C] (WRAS approved models).
Water Inlet Connections
Specification Requirement
Water inlet connection size, in.
[mm] 1 [25.4]
Recommended pressure, PSI
[bar] 43-73 [3-5]
Table 18 continues...
Water Inlet Connections
Specification Requirement
Inlet flow capacity per inlet,
gal/min at 15 PSI [l/min at 1
bar] 48.34 [183]
Inlet flow capacity per inlet,
gal/min at 116 PSI [l/min at 8
bar] 136.38 [518]
Table 18
Use the water inlet hoses that accompany the washer as they are
properly adapted to the water valves and appliance. NEVER use
a rigid connection to the water supply.
Do not re-use water hoses. Use only new water hoses.
The 1 inch inlet hose has on both side BSP thread (International
version). North American models has on both side NPSH threads.
For best operation of the washer, it is necessary to keep the water
pressure within the limits stated in
General Specifications . Water
pressure that is below minimum requirements can lengthen the
wash cycle and/or not allow proper function of the washer.
Connections should be supplied by a hot and a cold water line per
national and local codes and in accordance with IEC 61770.
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
35 Part No. D2601EN