Alliance Laundry Systems UY350 PROFORM TOUCH, Установка, эксплуатация и обслуживание

Страница: 55 / 63

2. Clean the door glass and between the door gasket and the
door with a damp cloth.
3. Clean supply dispenser lid and general area with mild deter-
gent. Flush the dispenser with clean water.
4. Clean the machine’s top, front and side panels with all-pur-
pose cleaner. Rinse with clean water and dry.
IMPORTANT: Use only isopropyl alcohol to clean
graphic overlays. Never use ammonia-based, vine-
gar- based or acetone-based cleaners on graphic
overlays.
IMPORTANT: Do not use abrasive cleaners.
NOTE: Unload the machine promptly after each
completed cycle to prevent moisture buildup. Leave
loading door and dispenser lid open at the end of
each completed cycle to allow moisture to evapo-
rate.
5. Leave the loading door open at the end of each day to allow
moisture to evaporate.
6. Shut off water supply.
Monthly or After 200 Working Hours
1. Using a multipurpose lithium lubricant containing high pres-
sure consistency addition NLGI 2 or ESSO - BEACON EP 2).
Lubricate the seal and bearings with 2 strokes (2 cm
3
) while
the basket is rotating at wash speed. Refer to Figure 42 .
1. Rubber seal lubricator
2. Front bearing lubricator
3. Rear bearing lubricator
Figure 42
2. Check external liquid soap supply system for leaks including:
a. hose joints
b. screw joints
c. connections to the external liquid soap system
Every 3 Months or After 500 Working
Hours
1. Check the bearing house for leakage.
2. Make sure the machine is disconnected from main power sup-
ply by the laundry switch or circuit breaker and that the other
workers are well informed about the machine maintenance ac-
tivity.
3. Check the tightness of the bolts. If any of the bolts have been
damaged, exchange it with a bolt of the same strength value
marked on its head. Tighten any loose bolts using the torque
value stated in the tables below. Refer to
Table 28 .
4. Visually check the pipe and hose connections inside of the
machine for leaks.
5. Make sure that the control components are protected against
moisture and dust during clean up. Wipe and clean inside of
machine.
6. On machines with electric heat, check the tightening of the
contacts of heating element terminals and other power termi-
nals (main switch, fuse disconnectors and contactors).
7. Put cover back on and switch on power supply by main laun-
dry switch or circuit breaker.
8. If there is an earth leakage trip installed in the inlet circuit of
the laundry electric switch board, test it.
WARNING
A qualified technician must test the earth leakage
trip (ground) function at least once every 3
months.
C219
9. On machines with tap sample open and close the tap several
times and let it flow some small quantity of water. You will
prevent the valve from becoming clogged.
10. Press the test push button of the earth leakage trip while it is
under tension. The earth leakage trip must go off.
35 - 60 kg / 350 - 600 L Models
CZW21NA
A
B
C
D
E
Figure 43
Maintenance
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
55 Part No. D2601EN