Alliance Laundry Systems HWFB61QN1102, Руководство по обслуживанию

Страница: 114 / 138

112
801683
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
• Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
52. DOOR SWITCH
a. Open loading door.
b. Carefully remove wire clamp ring from groove
with small flat blade screwdriver. Spring is
located in the 6 o’clock position. Refer to
Figure 27 .
NOTE: To avoid damage to spring, use screwdriver
on wire clamp ring to right or left of spring.
c. Grasp loading door seal lip. Refer to Figure 46 ,
Step “1”.
NOTE: To avoid damage to door seal, DO NOT use
pliers or sharp objects to grasp the door seal lip. If
lip is damaged, seal will leak.
d. Using a circular motion, pull seal up
( Figure 46 , Step “1”), out ( Figure 46 , Step
“2”), and down ( Figure 46 , Step “3”).
e. When seal releases from lip of front panel, pull
out and remove the seal from front panel around
door opening. Refer to
Figure 46 , Step “4”.
f. Reach up between door seal and front panel.
Refer to Figure 48 . Press in on switch locking
tabs and push switch out through front panel
only far enough to allow removal of wires from
switch terminals.
IMPORTANT: Refer to wiring diagram when
rewiring switch.
53. DOOR LATCH SWITCH
a. Open loading door.
b. Carefully remove wire clamp ring from groove
with small flat blade screwdriver. Spring is
located in the 6 o’clock position. Refer to
Figure 27 .
NOTE: To avoid damage to spring, use screwdriver
on wire clamp ring to right or left of spring.
c. Grasp loading door seal lip. Refer to Figure 46 ,
Step “1”.
NOTE: To avoid damage to door seal, DO NOT use
pliers or sharp objects to grasp the door seal lip. If
lip is damaged, seal will leak.
d. Using a circular motion, pull seal up
( Figure 46 , Step “1”), out ( Figure 46 , Step
“2”), and down ( Figure 46 , Step “3”).
e. When seal releases from lip of front panel, pull
out and remove the seal from front panel around
door opening. Refer to
Figure 46 , Step “4”.
f. While supporting door lock from the back
(through door opening), remove two Phillips
head screws holding door latch switch to front
panel. Refer to
Figure 48 .
g. Gently pull door lock out through door opening.
Remove door lock only far enough to
disconnect harness connector from door lock.
Refer to
Figure 48 .
NOTE: When installing new door lock, be sure to
install small lip through mounting hole first and
then rotate lock into position.
54. MOTOR
NOTE: Motor is removed out through front of
washer, however, as an option, motor can be
removed out through lower rear access panel
opening.
Motor Removal –
a. While supporting lower front access panel,
remove two screws from bottom edge of panel
and remove panel. Refer to
Figure 25 .
b. Front Control Washers –
(1) Remove control panel. Refer to Paragraph
38 or 40 .
(2) Remove two screws holding front of
cabinet top to top front edge of control
cabinet front. Refer to
Figure 22 .
Rear Control Washers –
(1) Using the special tool, No. 318P4, remove
dispenser drawer. Refer to Figure 26 .