Allen-Bradley 1783-WAPAK9, Руководство пользователя

Страница: 526 / 612

526 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 20 Configuring Repeater and Standby Access Points and Workgroup Bridge Mode
2.
Enter interface configuration mode for the radio interface.
–
The 2.4 GHz radio and the 2.4 GHz 802.11n radio is 0.
–
The 5 GHz radio and the 5 GHz 802.11n radio is 1.
dot11 dot11radio { 0 | 1 }
3.
Establish the time in seconds that the antenna alignment test runs before
timing out. The default is 5 seconds.
antenna-alignment timeout
Use the
show dot11 antenna-alignment
command to list the
MAC addresses and signal level for the last 10 devices that responded to
the probe.
Verifying Repeater Operation After you set up the repeater, check the status indicators on top of the repeater
access point. If your repeater is functioning correctly, the status indicators on the
repeater and the root access point behave like this:
•
The status indicator on the root access point is steady green, indicating
that at least one client device is associated with it, in this case, the repeater.
•
The status indicators on the repeater access point is steady green when it is
associated with the root access point and the repeater has client devices
associated to it. The repeater's status indicator flashes (steady green for 7/8
of a second and off for 1/8 of a second) when it is associated with the root
access point but the repeater has no client devices associated to it.
The repeater access point appears as associated with the root access point in the
root access point's Association Table.