Allen-Bradley 1747-OC Series, Руководство пользователя

Страница: 96 / 126

1747-UM001A-US-P - March 2000
8-2 Troubleshooting
The diagnostic utility disk contains these utilities:
This utility selection: Uses this executable:
OC scanner diagnostics
\scanner\ocdiag.exe
This utility exercises the functionality of the open controller and tests scanner communication to
the I/O modules in the 1746 chassis. This utility runs under DOS or in a DOS shell under Windows
3.x or Windows 95.
A version of
ocdiag.exe
that runs under Windows NT is available by contacting Rockwell
Automation Technical Support at 440-646-6800. You can also download a copy from the TSS
Bulletin Board using a modem at 440-646-5441.
KTX DH+/DH-485 diagnostics
\ktxdiag\ktxdiag.exe
This utility verifies KTX/D operation on the DH+ or DH-485 network. This utility performs onboard
KTX/D tests and verifies memory location and interrupt selection for the KTX/D. This is the same
utility that ships with the 1784-KTx communication card.
KTX RIO scanner diagnostics
1747-OCE:
\ktsdiag\kts_diag.exe
This utility verifies operation of the KTX/D as a remote I/O scanner. Use this utility to modify I/O
image tables and perform block-transfers. The
kts_diag.exe
utility requires
ansi.sys
to be loaded in the
config.sys
file.
1747-OCF:
\ktsdiag\scandiag.exe
This utility verifies operation of the KTX/D as a remote I/O scanner. Use this utility to modify I/O
image tables and perform block-transfers. The
scandiag.exe
utility requires
ansi.sys
to be loaded in the
config.sys
file.
PCI backplane/card utility for DOS
\pci\ocpci.exe
This utility prints to the screen the current PCI information, such as assigned PCI interrupts and
memory locations of modules installed in the PCI expansion bus. This utility is a DOS-executable
program only.
Use the
-v
(verbose mode) switch to display additional PCI information. Note that this utility
displays an extra PCI slot that physically is not there, which is intended for engineering
development purposes only.
You can run
ocpci.exe
in DOS 6.22 or in a DOS shell within Windows 3.x or Windows 95.
PCI backplane/card utility for
Windows NT
\pci\ocpci_nt.exe
This utility prints to the screen the current PCI information, such as assigned PCI interrupts and
memory locations of modules installed in the PCI expansion bus. This utility is a Windows
NT-executable program only.
Use the
-v
(verbose mode) switch to display additional PCI information. Note that this utility
displays an extra PCI slot that physically is not there, which is intended for engineering
development purposes only.
The runtime API for Windows NT must be loaded before executing this utility.
If you don’t have the runtime API, you can boot to DOS (possibly by using the
hostsvr
utility)
and run
ocpci.exe
. The system resources are allocated independently of the operating
system being run and don’t change unless you modify system hardware.