Alfa Laval ALTB-SB-20, Инструкция по эксплуатации

Страница: 44 / 74

8 Appendix
Ensure totally clean surfaces during mounting. Always use original Alfa Laval parts.
8.4 Drive unit lubrication
Product information
Klübersynth UH1 6 oils
Synthetic gear and high-temperature oils for the
food-processing and pharmaceutical industries
Klübersynth UH1 6-100, 150, 220, 320, 460, 680, en Edition 12.09, replaces edition 07.09
article number: 096094, 096058, 096059, 096063, 096060, 096064 MA-TM/HSi
Benefits for your application
The oils meet the requirements according to DIN 51 517 – 03, CLP
Registered by NSF as H1 lubricants for use in food-processing and pharmaceutical
industries, complies with FDA 21 CFR Sec. 178.3570
ISO 21469 certified – supports the compliance with the hygienic requirements in your
production. You will find further information about ISO Standard 21469 on our website
www.klueber.com.
Much longer service life than mineral oils due to the excellent ageing and oxidation
resistance of the base oil; thus maintenance intervals can be extended and in certain
cases even lifetime lubrication is possible
Owing to the wide service temperature range it is possible in many cases to use just one
viscosity grade for both low and high temperatures
The optimum friction behavior of the polyglycol base oil reduces power losses and
improves efficiency
The good wear protection of both gears and rolling bearings ensure that the service life
calculated for the lubricated components is achieved.
The oils' high micropitting resistance offers sufficient protection to gears that are
subject to high loads and would normally be susceptible to this type of damage.
The excellent viscosity-temperature behavior supports the formation of a sufficient
lubricating film even at elevated and high temperatures.
Seals made of 72 NBR 902, 75 FKM 585 and 75 FKM 170055 are resistant against
Klübersynth UH1 6 oils.
Approved by Flender, Siemens Geared Motors, SEW Eurodrive, Getriebebau Nord,
Stöber Antriebstechnik, Lenze, ZAE Antriebstechnik Baldor, Boston Gear, Bonfiglioli,
Watt Drive etc.
Description
Klübersynth UH1 6 oils are gear oils on a
polyglycol basis. They have a high scuffing load
capacity and
micro-pitting resistance. These oils have also
proved their good wear protection in rolling
bearings on the FAG FE 8 test rig for gear oils.
Klübersynth UH1 6 oils stand out for their
excellent ageing and oxidation resistance, good
viscosity-temperature behaviour and very good
thermal stability.
Application
Klübersynth UH1 6 oils are used for the
lubrication of bevel and spur gears, rolling and
plain bearings as well as all types of denture
clutches, especially when exposed to high
temperatures.
Klübersynth UH1 6 oils were especially
developed for the lubrication of worm gears with
steel/bronze pairings.
The polyglycol base oils and special additives
reduce the friction coefficient and provide low
wear values, which is a clear advantage in
these applications.
44