Alfa Laval ALTB-SB-20, Инструкция по эксплуатации

Страница: 13 / 74

3 Installation
The instruction manual is part of delivery. Study the instructions carefully.
The Agitator is for permanent fastening.
Make sure the motor corresponds to the environment.
Check the direction of rotation before operation.
Step 5
3.4.2 See illustrations, 7.1, 7.2, and 7.5.3.
A. Mount the “Bearing For Bottom Console” pos. 25 into the “Bottom Console” pos. 74.
B. Clean all shafts, propellers and Guide Spindel (pos. 69) threads for grease.
C. Assemble the shaft and propeller unit inside the tank with gaskets, o-rings and Loctite
®
: pos. 24, 30, 35, 69, 71, 72, 73, 75,
76 and slide it carefully down/into the “Bottom Console pos. 74” with the “Bearing For Bottom Console” pos. 25.
D. Avoid hard bumping against the bottom console bearing.
E. Tighten all threads till 100-200 Nm.
F. Mount the “Gasket” pos. 101 and the “Top Plate” pos. 100 – tight with a couple of screws.
G. Press the “Spray Ball Bearing” pos. 26 into the “Spray ball”, pos. 8.
H. Mount the “Spray ball” pos. 8 (incl. the “Spray ball Bearing” pos. 26) onto the “Tube, CIP for Spray Ball” pos. 3 using the
“Spring lock for spray ball” pos. 9
I. In some cases all the parts can be assembled outside the tank and lowered into the tank assembled.
J. Insert the “O-Ring” pos. 33 into the “Tube, CIP for Spray Ball” pos. 3.
K. Position the “Tube, CIP for Spray Ball” pos. 8 onto the “Top Flange” pos. 100.
13