Ki Pro GO File Based Recorder/Player v1.0 13 www.aja.com
Rear Panel
Figure 3. Ki Pro GO Rear Panel
Video
Reference
(looping)
USB 3.2 Gen 1
Port (#5)
Status LED
(#5)
Redundant
DC Power
Inputs
SDI Channel
Outputs
1-4
SDI
Inputs
1-4
HDMI
Inputs
1-4
HDMI
Monitor
Output
SDI
Monitor
Output
Ethernet
LAN
ID LED
Balanced Analog
Audio Input
L/R (XLR)
Analog Audio
Monitor Out
Mic/Line/48V
Switches
Ref Loop
The Reference Loop BNCs accept a reference timing signal. Incoming video
sources do not have to be genlocked due to Ki Pro GO's input frame syncs.
The reference, if used, can be analog SD blackburst or HD tri-level sync. The two
BNCs are a passive loop: one BNC is for the Input, and the remaining BNC can be
connected to another piece of equipment in the reference chain or terminated.
NOTE: For proper operation the input reference signal must be stable and properly
terminated using a 75-ohm terminator on either the unused loop connector
or the last piece of downstream equipment to which the reference video is
connected.
SDI Inputs
Four input BNC connectors are provided, each supporting 3G-SDI video up to
1080p 60, and each accepts the first two channels of embedded 24-bit digital
audio. Only single link SDI video is supported.
Each input can be routed to any or all of the four Ki Pro GO recording channels.
Up to four video inputs can be recorded as clips at the same time.
Two channels of audio and VPID are preserved. All other ANC data will be lost.
SDI Channel Outputs
Four output BNC connectors are available, each supporting 3G-SDI video up to
1080p 60, and includes two channels of embedded 24-bit digital audio.
Each numbered SDI output BNC is linked one-to-one to each of the four
Ki Pro GO's recording/playback channels' output. Because the SDI (and HDMI)
input signals can be routed, the SDI output BNC s not necessarily associated with
the similarly numbered SDI input BNC.