F
3
SAT-17T Fusion Splicer Instruction Manual
splicer off and disconnect the AC power cord before replacing
the electrodes.
Safety goggle should always be worn during optical fiber
preparation and splicing operation. Optical fiber fragments can
be extremely dangerous if it comes into contact with the eye,
skin, or has been ingested.
Check the AC power source before use. Proper AC power source
is in range of AC100-240V, 50/60Hz. Improper power source
may be resulted in fuming, electric shock or equipment damage,
and may results fire, personal injury or death.
Do not short-circuit the terminals of AC adapter and battery.
Excessive electrical current may cause personal injury, burning,
electric shock and other damages for equipment.
Do not touch the splicer AC power cord and AC plugs with wet
hands. These may result electric shock.
Do not operate splicer nearby hot objects, or in hot temperature
environments; don’t store splicer in dusty/humid atmospheres
environment. These may result electric shock, splicer
malfunction or poor splicing performance.
When using optional battery, follow the instruction below.
Failure using may result in explosion or personal injury.
Don’t charge battery with other methods than instructed in
this manual.
Do not discard battery into an incinerator or fire.
Do not charge or discharge battery near a flame or under
direct sunlight.
Do not excessively shake or jar the battery.
If battery leaks of liquid residue, be careful handling the
