AgXcel Synergist GX40 System, Справочное руководство, Страница: 13 / 36

13
877.218.1981 info@agxcel.com
Revised09.2018R1
WWW.AGXCEL.COM 877-218-1981 info@agxcel.com
• On the Calibration page, select Field-IQ then
press Calibrate button
• This will bring you to the Field-IQ Configuration
screen
• Select Drive Calibration
• You can leave Maximum Flow set to 0 or enter
the Maximum Flow rate of your pump in Gal/
Min. Then press Next
• Follow the screen instructions to run Auto Tun-
ing procedure.
• Press Next at the bottom of the screen to go to
the Drive Settings .
• The settings on the Drive Settings screen are all
duplicated on the Advanced Parameters screen.
Press the Advanced Parameters button to go to
the next screen.
• On the Advance Tuning page, set the settings as
shown:
• Upper PWM Limit:
100
Lower PWM Limit:
GX5 (hydraulic)……………28
GX2 (electric)………………0
Synergist…………………….0
Integral Gain: (Adjust as needed)
GX5 (hydraulic)……………10
GX2 (electric)………………15
Synergist…………………….100
Minimum Response: (Adjust as needed)
GX5 (hydraulic)……………20%
GX2……………………………..0%
Synergist……………………..5%
Allowable Error:
GX5 (hydraulic)……………1%-3%
GX2……………………………..3%
Synergist……………………..5%
Smoothing Factor:
GX5 (hydraulic)……………1%-3%
GX2……………………………..3%
Synergist……………………..1%
Field IQ Calibration
NOTE : The TMX-2050
will use Proportional
Gain instead of the In -
tegral Gain. This is the
opposite of the FmX.
The Auto Tuning pro -
cess should set this. If
not, start with Propor-
tional Gain at 20-30.
Quick Start Setup Instructions for Trimble’s FM
750, FM1000, FMX Rate Controller
GX40 Synergist .... 0
GX40 Synergist .... 100
GX40 Synergist .... 5%
GX40 Synergist .... 5%
GX40 Synergist .... 1%
AGXCEL INTEGRATION INTO THE TRIMBLE
(Read Instructions Completely before Beginning Installation)