www.agxcel.com
10
WWW.AGXCEL.COM
877-218-1981
Rate Control
• Select the
Rate Control
tab at the top of the screen.
• Set
Rate Control
to
ON
• Set
Number of Nozzles
(number of rows)
• Set
No/Low Flow Timeout
to 45 s for troubleshooting so the system does not shut off too quickly.
• Press
Setup
next to
Rate Control Module Location
.
•
Set the correct information on the
Rate Control Module Setup
screen.
• Press
OK
•
Trimble will take you back to the screen you see above. On
Drive Setup
, press
Setup
.
•
Rate Control
(Continued)
• Set up the
Valve Setup
as shown:
•
Valve Type:
PWM
•
Valve Behavior When Sections Closed:
Close
•
Auxiliary Valve:
Disabled
(
OPTIONAL
:
If using an
Aux/Dump valve
to keep the pump run
-
ning when application stops so the system will resume applying at
the
Target Rate
immediately upon restart, set
Auxiliary Valve to
Dump
, then set
Valve Behavior
when
Sections Closed
to either
Lock in Last Position or Lock at Minimum
. This setup requires sec-
tion valves with an additional dump valve plumbed to return flow
to the tank when application stops.)
Press
Feedback Setu
p button on the
Drive Setup
page.
Set the Feedback Setup as shown:
•
Flow Meter Type:
Other
•
Flowmeter Calibration:
See AgXcel
Flow Meter Guide
•
Minimum Flow:
0.0 GPM (Can be
set to the minimum specification
for the flow meter.)
Quick Start Setup Instructions for Trimble’s FM
750, FM1000, FMX Rate Controller
AGXCEL INTEGRATION INTO THE TRIMBLE
(Read Instructions Completely before Beginning Installation)
Содержание Synergist GX40 System
Страница 36: ......