Version May 2021
EN
19
agru SP 63 mobile
V 3
User’s Manual
agru Kunststofftechnik GmbH
Ing.-Pesendorfer-Str. 31
4540 Bad Hall, Austria
Both kinds of deletion in the additional parameter management
menu — deletion of the welding parameter set previously selected in the
overview list and deletion of all additional welding parameters — require
the subsequent confirmation of two warning messages.
Info
If the product/material that was used in the last welding opera-
tion is deleted, the product/material selection screen (refer to
Sect. 4.3) opens automatically upon closing the parameter set
management, then the configuration menu, and a new product/
material has to be selected.
4.6 Fastening the Mechanical Structure of the Machine
The mechanical structure (chassis) of the machine is fastened to or
unfastened from the base plate using the lock frames that the black
anodized-aluminum legs of the structure plug into (see left-hand drawing
for reference). The leg is secured inside the frame by the fastening latch
at its back (seen only in the right-hand drawing), which, in turn, is kept
in place by the lock flap hooked into the fastening latch and then tilted
towards the back, along the leg. The traction excercised on the fasten-
ing latch by the flap can be adjusted by shortening or lengthening the
threaded pin that hooks into its mate at the edge of the latch.
The grooves in the base plate help slide the legs of the mechanical
structure into the lock frames into which the plug.
Prior to fastening or unfastening the mechanical structure, discon-
nect all electrical and control cables; reconnect only when
done.
A second step of fastening the mechanical structure to the base
plate, when it is not planned to use it separate from the plate, is to
lock the plates to each other by sliding the one into the other and
securing it using the locking ball pins at the front right and back
left corner of the plate of the electronic control unit (see drawing
to the right, which only shows the locking ball pin at the rear). To
unlock a locked pin, push down the head of the pin inside the head.
To conclude the preparations of the welding process, connect
the two control cables: the one shown on the drawing to the right to the
connector at the back of the mechanical structure and the one from the
heating element to that on the right-hand side — when looking at the
keypad — of the electronic control (see Sect. 3.2.2).
Caution
When the mechanical structure is properly fastened to the base
plate, the fastening elements ensure a safe welding operation.
If the machine is used without the base plate, make sure that it
is positioned safely — including sufficiently far away from flam-
mable and combustible substances — at the components to be
jointed and that any needed means and auxiliaries of support
are indeed used.
