Version May 2021
16
EN
agru SP 63 mobile
V 3
User’s Manual
agru Kunststofftechnik GmbH
Ing.-Pesendorfer-Str. 31
4540 Bad Hall, Austria
Bead Force while
Welding
if ON: During welding, the diagram depicted on the screen
represents the force exercised on the welding bead (i. e., for
instance, no force in the heating stage, as the applied force is not
exercised on the bead);
if OFF: The force depicted by the diagram in the course of the
welding process is the value exercised on the force transducer.
Select Language
In a sub-menu, the display language of the machine can be selected
(see Display 1 for reference).
Automatic Mode
if ON: steps of the process where the movable carriage of the
machine actually moves can be performed by starting its movement
using the carriage mover button in the lower left corner of the
screen; once started, the movable carriage will move to the left or to
the right for the proper duration computed by the machine for the
currently ongoing welding process step or available in the recorded
process data of a previous welding operation (see the “Important”
note at the beginnig of Sect. 4.7);
if OFF: steps of the process where the movable carriage moves re-
quire the carriage mover button to be used as an on-demand switch,
i. e., to be maintained in the pressed state for the full duration for
which the carriage is meant to move to the left or to the right. In this
event, it is under the welder's responsibility to monitor the duration
of the movement and the position of the moving carriage.
While the configuration menu is being displayed, two more buttons can be
seen in the navigation bar at the right-hand edge of the screen. The
button gives access to the system settings of the welding machine. They
are meant for specialized staff supposed to set up, service or, if failed,
repair the machine; therefore, they are not described in this booklet.
Just as the system settings, the extended operation settings of the
welding system, which can be accessed by touching the
button,
are protected by a second access code, which will be disclosed only to
supervising staff with the operator. The parameters below can be custom-
ized in the extended set of settings after entering that code.
Designation
Setting
Description / Data to be entered
Memory Control
if ON: The machine refuses further welding operations when the
memory is full;
if OFF: The machine overwrites the oldest report when the memory
is full.
Set Date/Time
In a sub-menu, date and time can be set, provided no service of the
machine is currently due.
Delete Reports
In a sub-menu, it is possible to delete
all
welding reports currently in
memory; the reports will be deleted only after another tweo safety
warnings were confirmed.
Enter Additional
Parameters
In a sub-menu, the characteristic welding parameters can be defined
for product/materials that are not available in the control software.
Enter Inventory
Number
In a sub-menu, the identifier can be entered by which the machine
has been entered in the inventory of its operator.
4.3 Changing Key Parameters of the Welding
In the default screen (see Display 3), it is possible
to change the specific parameters for the joint to
be welded. To do so, press the
button. The
screen that allows selecting the material of the
components that are going to be welded, is then
displayed on the screen (see Display 5).
Info
The first selection screen may comprise
not only component materials, such as
PVDF or PP, but also so-called prod-
Display 5
