Agilent Technologies Intuvo 9000, Установка и первый запуск

Страница: 74 / 114

74 Agilent Intuvo 9000 GC Installation
1
Installing the GC
chip compression bolt through the top of the GC as shown
below.) See
Figure 13 .
Figure 13 Loosening the Guard chip compression bolt (split/splitless
inlet shown)
d
Use the torque driver to open the clips that secure the
inlet chip to the bus. See
Figure 10 .
e
Orient the new inlet chip. Slide the bottom connector of
the inlet chip behind the Smart ID connector wire for the
detector chip, and insert the bottom connector into the
column fitting on the bus. Then, insert the top connector
into the pocket in the little bus. See
Figure 10 .
f
Seat the chip's column connector into the column fitting.
g
Check your work. Both click and run connectors should be
centered in their fittings, the chip's connector in the
Intuvo torque
driver shaft
CAUTION
Make sure the connectors are fully seated in the column fitting and
little bus.