Agilent Technologies 8719D, Руководство пользователя

Страница: 410 / 673

Figure 6-76. Gate Shape
Selecting gate shape.
The four gate shapes available are listed in 6-11. Each gate has a
different flatness, cutoff rate, and levels.
6-11. Gate Characteristics
Normal
Wide
Maximum
-68
-67
-70
Span
Span
Span
span
span
Span
span
The ripple and levels are descriptive of the gate shape. The cutoff time is the
time between the stop time (-6 on the skirt) and the peak of the sidelobe, and
is equal on the left and right side skirts of the Because the minimum gate span has no
passband, it is just twice
the cutoff time.
Always choose a gate span wider than the minimum.
For most applications, do not be concerned about the minimum gate span, simply use the knob
to position the gate markers around the desired portion of the time domain trace.
Transforming CW Time Measurements into the Frequency Domain
The analyzer can display the amplitude and phase of CW signals versus time. For example, use
this mode for measurements such as amplifier gain as a function of warm-up time (i.e. drift).
The analyzer can display the measured parameter (e.g. amplifier gain) for periods of up to
24 hours and then output the data to a digital plotter for hardcopy results.
These “strip chart” plots are actually measurements as a function of time (time is the
independent variable), and the horizontal display axis is scaled in time Transforms of
these measurements result in frequency domain data. Such transforms are called forward
transforms because the transform from time to frequency is a forward Fourier transform, and
can be used to measure the spectral content of a CW signal. For example, when transformed
into the frequency domain, a pure CW signal measured over time appears as a single frequency
spike. The transform into the frequency domain yields a display that looks similar to a
spectrum analyzer display of signal amplitude versus frequency.