Agilent Technologies 8719D, Руководство пользователя

Страница: 619 / 673

If the Peripheral Interface Is Serial
Select for a printer, or ‘PORT for a plotter peripheral.
Press and enter the peripheral baud rate, followed by
3. Select the transmission control method that matches the peripheral setup, by pressing
ransmit control handshaking protocol) until the correct method appears,
. the handshake method allows the peripheral to control the data
exchange sequence by telling the analyzer when it has room in its buffer for data and
when to stop the data flow. The peripheral uses buffer threshold indicators (an Xon trigger
character and an Xoff trigger character) to prevent buffer overflow.
. If you choose a handshake method takes place in the hardware rather than the
firmware or software. If there is enough room in the peripheral’s buffer to accept and
store another block of data, the peripheral sets the Data Ready (DTR) line to a
high state.
If the Peripheral Interface Is Parallel
.... . .
1. a or a
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
peripheral.
Press and select the port interface function, by pressing until the
correct function appears:
use (printers or plotters).
and cannot be used for printing or plotting. analyzer controls the data input and
output, through the sequencing capability of the analyzer.
Note
All copy configuration settings are stored in non-volatile memory. Therefore,
the settings are not affected by preset or power conditions.
11-14