Agilent Technologies 1100 Series, Руководство по обслуживанию

Страница: 230 / 288

218 1100 Series Nano Pump Service Manual
5 Introduction to the Nano Pump
Interfaces
The Agilent 1100 Series modules provide the following interfaces:
• CAN connectors as interface to other Agilent 1100 Series modules,
• GPIB connector as interface to the Agilent ChemStation,
• RS-232C as interface to a computer,
• REMOTE connector as interface to other Agilent products,
• Analog Output connector(s) for signal output, and
• Interface slot for specific interfacing (external contacts, BCD, LAN and so
on).
For identification and location of the connectors Figure 5 on page 13.
Table 50 Agilent 1100 Series Interfaces
Interface Type Pumps Autosampler Well-plate
Sampler DA Detector
MW
Detector
FL Detector VW Detector
RI Detector Thermostatted
Column
Compartment Vacuum
Degasse
r
CAN Yes Yes Yes Yes Yes Yes No
GPIB Yes Yes No
*
Yes Yes Yes No
RS-232C Yes Yes Yes Yes Yes Yes No
Remote Yes Yes Yes Yes Yes Yes Yes
Analog Yes No No 2 × 1 × No Yes
†
Interface board Yes Yes Yes Yes Yes No No
* The well-plate sampler can be controlled through CAN via a detector that is connected via GPIB to a ChemStation.
† The vacuum degasser will have a special connector for specific use. For details see description of main board.
WA R N I N G
Never use cables other than the ones supplied by Agilent Technologies to ensure
proper functionality and compliance with safety or EMC regulations.