AGA 100 G FSD, Руководство пользователя, Страница: 36 / 44

I. To Remove Electrode
1. Isolate from electric supply.
2. Proceed as ‘TO REMOVE SPARK GENERATOR’
disconnect the appropriate electrode lead.
3. Proceed as TO REMOVE THE HOTPLATE’.
4. Withdraw clip securing electrode to burner and
withdraw lead and electrode (see fig. below).
5. Re-assemble in reverse order.
J. To Remove Grill Element
1. Isolate from electric supply.
2. Remove two screws securing grill pelmet and remove
pelmet.
3. Remove two screws securing grill element fixing to
carrier to grill cavity and allow element and carrier to
hinge down from the rear.
4. The element can now be lifted out of the carrier to
allow access to the electric terminals at the rear.
5. Disconnect the terminals taking note of their
termination sequence and routing to avoid trapping
cables during re-assembly.
6. Re-assemble in reverse order.
K. To Remove Doors
1. Open door fully.
2. Rotate hinge locking disc 90º clockwise on both door
hinges to lock door in open position.
3. Carefully close door and at approximately half closed
the hinges will release themselves from the cooker
frame.
4. Re-assemble in reverse order.
L. To Remove Oven Door Seal
1. Open oven door. The seal is held in place by small
hooks on the rear face. At the corner pull seal
diagonally away from the door centre until the hook is
released.
2. Proceed to the next hook and release it in a similar
way, and so on. Use force if the hooks are stiff, as the
old seal will be discarded.
3. Hook the new seal in one of the corner holes of the
door and proceed round the door opening snapping
each hook in turn.
SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished
36