
4. Slacken timer fixing screw sufficiently to allow timer
securing strip to slide out of facia panel.
5. Re-assemble in reverse order.
E. To Remove Gas Taps/Ignition Switches
1. Isolate from electric supply.
2. Proceed as ‘TO REMOVE HOTPLATE’.
3. Proceed as ‘TO REMOVE SIDE PANEL’.
4. Undo burner gas pipe to tap (15mm nuts).
5. Remove two screws securing tap to gas rail.
6. Withdraw gas tap from gas rail taking care not to strain
ignition switch cables.
7. Disconnect ignition switch cables and slide off switch
activating collar from spindle of tap.
8. Re-assemble in reverse order.
NOTE: Always fit new ‘O’ ring gas seal and check for
gas soundness.
F. To Remove Grill Regulator/Light Switch
1. Isolate from electric supply.
2. Proceed as ‘TO REMOVE FACIA CASTINGS’.
3. Remove two screws securing control to control
mounting panel.
4. Withdraw control and cables taking care not to strain
the cables.
5. Disconnect cables from the control.
NOTE: Take care to identify terminations.
G. To Remove Oven Thermostats
1. Isolate from electric supply.
2. Proceed as ‘TO REMOVE GRILL REGULATOR’.
3. Remove (10) back panel screws.
4. Remove thermostat phial and capillary through back of
cooker, note correct capillary route.
5. Re-assemble in reverse order.
H. To Remove Spark Generator
1. Isolate from electric supply.
2. Lower front mobility wheels (see section ‘MOBILITY
WHEELS’ in Users instructions) and pull cooker
forwards to gain access to the rear of the cooker.
CAUTION: DO NOT STRAIN FLEXIBLE GAS
CONNECTION disconnect if necessary.
3. Remove mains cable inlet cover, 8 screws.
4. Disconnect electric cables to generator.
5. Remove two screws securing generator mounting
bracket to cooker frame and carefully withdraw
generator sufficiently to disconnect electrode leads.
6. Re-assemble in reverse order.
SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished
35
Содержание 100 G FSD
Страница 43: ...43...