AGA 100 G FSD, Руководство пользователя, Страница: 22 / 44

The Slow Cooking Oven and the Grill
The slow cooking oven and the grill have side panels that
are coated with a special enamel that partly cleans itself.
Do not use any cleaning material which may clog the
pores of the special coating e.g. Pastes and powders,
soap filled pads, wire wool, spray cleaners, brush-on oven
cleaners, caustic solutions, metal scrapers/knives, and
prevent the continuous cleaning action.
The shelf is designed to lock in place, but is removable for
cleaning. To remove lift up at the front then pull forward.
The grill pan and grid should be washed in hot soapy
water.
After grilling meats or any foods that soil, leave to soak for
a few minutes in the sink immediately after use. Stubborn
particles may be removed from the grid by using a nylon
brush.
Control Panel and Oven Doors
For best results liquid detergents should be used.
The control panel and control knobs should only be
cleaned with a soft cloth wrung out in clean hot soapy
water - but take care that no surplus water seeps into the
appliance. Wipe with a clean dampened cloth then polish
with a dry cloth. The oven doors should only be cleaned
with a soft cloth wrung out in clean soapy water.
The Lower Gas Ovens
The ovens have panels which have been coated with a
special enamel that partly clean itself. This does not stop
all marks on the lining, but helps to reduce the amount of
manual cleaning needed.
The panels work better above Mark 7. If you do most of
your cooking below this temperature, occasionally wipe
with a lint free cloth and hot soapy water. When the panels
are dry, heat the oven to Mark 8 for about one hour. This
will ensure the panels are working effectively.
Do not use steel wool (Brillo) or any other materials that
will scratch the surface. Do not use oven cleaning pads.
Oven doors with windows (some models
only)
If the inside face of the glass on the window door model
becomes marked, the glass panel can be taken off for
cleaning.
Open the oven door. To remove the glass turn the quick
release screws a quarter turn and carefully lift off the glass
panel. After cleaning the glass make sure that it is
completely dry before re-fitting.
Check that the glass is replaced in the correct way.
22