AGA 100 G FSD, Руководство пользователя, Страница: 31 / 44

When the cooker is level and in the correct position, the
two feet at the front corners of the cooker
MUST be
lowered to come into contact with the floor and support the
cooker (tighten the locknuts). The two front mobility
wheels must then be raised by at least one turn (anti-
clockwise of the adjusting screw) to ensure that the
cooker is locked in place and cannot accidentally roll out
of position.
Conversion to LP
If the appliance is to be converted to LP gas do the
conversion at this point. See the conversion section of
these instructions.
Fitting the splashback (optional)
To fit the splashback, the appliance must be moved out
slightly to gain access to the rear of the appliance.
Remove 4 screws as shown.
Fit new splashback as shown.
Gas Connection
Fitting a stability bracket
A stability bracket or chain (not supplied with the cooker)
should be fitted when the cooker is connected to a flexible
gas supply. Any restraining device should be secured to
the fabric of the building and should be able to be released
so that the cooker can be pulled out for cleaning and
maintenance.
When fitting a stability bracket read these instructions
together with the leaflet supplied with the bracket.
a. Position and level the appliance.
b. Draw a pencil line along the front edge of the base of
the cooker and along the right hand edge.
c. Remove the range.
d. Mark off 495mm from the RH side of the unit to indicate
the centre line for the bracket.
e. Mark off 415mm to locate the front edge of the lower
bracket. Fix bracket to floor.
f. Measure the height from floor level to the bottom of the
opening in the cooker back.
Add 3mm to this dimension and assemble the stability
bracket to this height (i.e. from floor level to underside of
top member).
31