AGA 100 G FSD, Руководство пользователя, Страница: 33 / 44

Electrical Connection
This appliance must be installed by a qualified electrician
to comply with the relevant regulations and also the local
electricity supply company requirements.
WARNING: THIS APPLIANCE MUST BE EARTHED.
NOTE :
The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker,
through a suitable cooker control unit incorporating a
double pole switch have a contact separation of at least
3mm in all poles. This cooker must not be connected to an
ordinary domestic power point.
The total electrical load of the appliance is approximately
8.8kW. The cable size used should be suitable for this
load and comply with all local requirements.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel.
Remember that an excess of cable length is required for
the possible withdrawal of the cooker.
Secure the mains cable using the cable clamp.
THE ISOLATOR MUST NOT BE POSITIONED
IMMEDIATELY ABOVE THE MASTERCHEF COOKER,
BUT MUST BE SITED WITHIN 2 METRES OF THE
APPLIANCE.
Current Operated Earth Leakage Breakers
Where the installation is protected by a 30-milliamp
sensitivity residual current device (RCD), the combined
use of your cooker and other domestic appliances may
occasionally cause nuisance tripping. In these instances
the cooker circuit may need to be protected by fitting a
100mA device. This work should be carried out by a
qualified electrician.
Hotplate
Check each burner in turn. There is a flame safety device
that stops the flow of gas to the burner if the flame goes
out. There is also a spark ignition system that works when
the knob is pressed in.
For each burner, push in and turn the knob to the large
flame symbol ( ).
The igniter should spark and light the gas. Keep holding
the knob pressed in to let the gas through to the burner for
a few seconds.
If, when you let go of the control knob, the burner goes
out, the safety device has not held in. Turn the control to
the off position and wait one minute, then try again this
time holding in the control knob for slightly longer.
Grill
Open the grill compartment door. Turn on the grill control
and check that the grill heats up.
Oven check
Turn on the ovens and check that they start to heat up.
Turn off the ovens.
Fitting the plinth
Remove the 2 screws along the front bottom edge of the
cooker. Hold the plinth in place and re-fit the 2 screws.
Customer Care
Please inform the user how to operate the cooker and
hand over these instructions.
Thank you.
33