AEROTECNICA COLTRI MCH 14 TECH NITROX SERIES, Инструкция по эксплуатации

Страница: 58 / 117

58
This chapter provides instructions to be followed for extended storage or for the dismantling of the
machine.
10.1 Instructions for extended storage ...................................................................................... 58
10.2 Disposal of waste products ................................................................................................ 58
10.3 Dismantling the machine ................................................................................................... 59
WARNING
Before carrying out any procedure on the machine, read Chapter 4, “Precautions for use and maintenance”
with care.
If the compressor is not to be used for prolonged periods, remove the activated carbon cartridge from the
strainer filter.
Run the compressor idle for a few minutes to drain off any residue condensate. Stop the compressor,
remove the intake filter, start up the compressor again spraying a few drops of oil into the intake hole so
that a light film of lubricant is sucked in and penetrates the internal parts of the compressor.
Stop the compressor and refit the intake air filter. Clean the external parts and try to remove any saline
humidity and oily deposits. Protect the compressor from dust and water by storing it in a clean, dry
place.
WARNING: DEPRESSURIZE THE UNIT.
Turn the machine off using the general switch (position “0”) and remove the power plug.
Carry out a general cleaning operation on the machine and all its components.
When using the compressor, special waste products are produced. It must be remembered that waste
from industrial processes, agricultural, artisan and commercial activities and service industries cannot
be disposed of together with normal urban waste either because of their quality or quantity.
Old or obsolete machinery is also to be considered as special waste.
Special care must be taken with the disposal of worn active carbon filters which, being a waste product
that cannot be disposed of together with normal urban waste, must be dealt with in compliance with the
laws in force in the country where the compressor is installed.
MACHINE SHUTDOWN AND DISMANTLING
PROCEDURES
10
10.1
Instructions for extended storage
10.2
Disposal of waste products
Machine shutdown and dismantling procedures