Aerotech MPS75SLE-025, Руководство по оборудованию

Страница: 15 / 48

MPS75SLE Hardware Manual Mechanical Specifications and Installation
Chapter 2: Mechanical Specifications and Installation
W A R N I N G : MPS75SLE installation must be in accordance to instructions provided by this
manual and any accompanying documentation. Failure to follow these instructions could result
in injury or damage to the equipment.
2.1. Unpacking and Handling the Stage
N O T E : If any damage has occurred during shipping, report it immediately.
Carefully remove the MPS75SLE from the protective shipping container. Before operating the MPS75SLE, it
is important to let the MPS75SLE stabilize at room temperature for at least 12 hours. Allowing the
MPS75SLE to stabilize to room temperature will ensure that all of the alignments, preloads, and tolerances
are the same as they were when tested at Aerotech. Use compressed nitrogen or clean, dry, oil-less air to
remove any dust or debris that has collected during shipping. Set the MPS75SLE on a smooth, flat, and
clean surface.
Each MPS75SLE has a label listing the system part number and serial number. These numbers contain
information necessary for maintaining or updating system hardware and software. Locate this label and
record the information for later reference. If any damage has occurred during shipping, report it immediately.
W A R N I N G : Make sure that all moving parts are secure before moving the MPS75SLE.
Unsecured moving parts may shift and cause bodily injury.
W A R N I N G : Improper handling could adversely affect the MPS75SLE’s performance. Use
care when moving the MPS75SLE.
W A R N I N G : An unsecured MPS75SLE could be dragged off of a mounting surface by its
unsupported cable. The weight of the MPS75SLE is less than the integral cable and connector.
W A R N I N G : Do not use the drive-screw or motor as lifting points.
www.aerotech.com Chapter 2 5