Aero AeroForce F2B, Руководство по установке

Страница: 15 / 30

15
AeroForce F2B
Installation Instructions
6) Secure the #6 wire (5) along the vehicle frame using clamp metal looms (20) and 1/4 x 3/4 pan head
Phillips (13) being sure to avoid any exhaust, moving parts, or sharp edges that could damage the wire's
protective coating. The wire should have a loop at the hinge point where the bed pivots on the frame. A good
rule of thumb is to match the loop of factory installed wires and lines or hoses. This will allow sufficient
flex during bed cycling operation. Insufficient or improper loop can result in wire damage when the bed is
raised.
7)
Measure distance between rocker switch (3) and reverse DC contactor (1). Wire switch (3) and reversing DC
contactor (1) according to diagram with #14 wire (6).
8) Measure distance between battery and reverse DC contactor (1) run #6 wire (5) between the two.
9) Install a circuit breaker (4) at or very near the battery's positive terminal. Secure circuit breaker in place
with a zip tie if possible to prevent movement.
10) Place the DC contactor cover (2) on the reversing DC contactor (1) and tighten the 1/4-20 bolts and nuts.
NOTICE: Circuit breaker must be properly installed or motor warranty is void.
Step 4a
(cont.)









Figure 15-1