Aero AeroForce F2B, Руководство по установке

Страница: 12 / 30

12
AeroForce F2B
Installation Instructions
Step 3a
Installing the Sprocket
1) Figure 12-1.
Slide the sprocket (1) over the outside
of the shaft of the driver's side roll up bar. Position
sprocket so that it aligns with the crank assembly
sprocket.
2) Lightly tap the key (2) into the shaft keyway.
3) Tighten the Allen set screw on the sprocket until it
begins to feel tight. Make sure the screw engages
the key (2). Do not over tighten.
Step 3b
Installing Manual Crank Assembly
NOTE: If you need to mount in a space where you cannot use bolts and nuts, use self-tapping bolts
and lock washers. Not included in the package.
1) Remove the cover (if installed) on the crank assembly and
lay cover aside until after the chain is installed.
2) Figure 12-2. Place the crank assembly at or near the
bottom front corner of the box on the driver's side. Rotate
the crank assembly so that it angles toward the tarp roll
up bar.
3) Mark the mounting holes on the box. Drill marked holes
using 13/32" drill bit.
4) Fasten the crank assembly to the box with bolts, washers,
and nuts. Make sure to bolt the assembly in the highest
upward position.
Index Description Qty
1 Crank Assembly 1
2 3/8 x 1 Self Tapping Hex Bolt 2
Index Description Qty
1 Sprocket 1
2 Key 1


1
2
Figure 12-1
2
1
Figure 12-2