Aero AeroForce F2B, Руководство по установке

Страница: 11 / 30

11
AeroForce F2B
Installation Instructions
Step 2d
Installing Electric Motor and Adjustable Roll Up Bar
NOTE:
Use hardware pack taped to roll up bar.
1) Figure 11-1. Fasten Motor Winch "B" (1) to driver's side end plate with 5/16-18 x 5/8 FHCS (3).
2) With screws provide with the motor attach the cover to the motor. (Cover will need to be removed for wiring.)
3) Remove hardware package and tape from center of adjustable electric roll up bar (2), one end is loose and
can slide off. Place hardware package to the side.
4) One end does not have a shaft. Remove the nut and bolt from that end. Insert end onto shaft of motor
winch "B", line up hole in roll up bar with hole in motor shaft, and with previously removed nut and bolt
secure roll up bar to shaft.
5)
Extend other end of roll up bar out and insert shaft through the bearing on the passenger's end of tarp
housing.
NOTE: Make sure there is clearance on the outside of tarp housing to allow shaft to stick out far
enough.
6)
With passenger's end of roll up bar within 1/4" - 1/2" of bearing drill two .257" (F drill) holes thru both
tubes as shown.
7) Secure outside tube to inside tube with two 1/4 x 2 1/4 Hex Bolts from hardware pack.
Index Description Qty
1 Motor Winch "B" 1
2 Adjustable Electric Roll Up Bar 1
3 5/16-18 x 5/8 FHCS 3
4 1/4-20 x 2 1/4 Hex Bolt 2
5 1/4-20 Nylon Hex Nut 2
.75 5.00 .25
1
2
3
4 5
Motor Cover
Cover Screws
.257" diameter (F Drill)
Thru both tubes
2 places
Hex nut and bolt
secures roll up
bar to motor shaft
Figure 11-1