Aero AeroForce F2B, Руководство по установке

Страница: 10 / 30

10
AeroForce F2B
Installation Instructions
Step 2c
Installing Manual Adjustable Roll Up Bar
NOTE:
Hardware pack is taped to roll up bar.
1)
Remove hardware package and tape from center of adjustable manual roll up bar, one end is loose and can
slide off. Place hardware package to the side.
2) One end of adjustable manual roll up bar has a shaft with a hole, insert this end through the bearing on the
driver's end of tarp housing.
3) Make sure driver's end of roll up bar is against bearing. Extend other end of roll up bar out and insert shaft
through the bearing on the passenger's end of tarp housing.
NOTE: Make sure there is clearance on the outside of tarp housing to allow shaft to stick out far
enough.
4) Figure 10-1.
With passenger's end of roll up bar within 1/4" - 1/2" of bearing drill two .257" (F drill) holes
thru both tubes as shown.
5) Secure outside tube to inside tube with two Tek screws from hardware pack.
Index Description Qty
1 Adjustable Manual Roll Up Bar 1
2 1/4-20 x 2 1/4 Hex Bolt 2
3 1/4-20 Nylon Hex Nut 2
.25
.75 5.00
.257" diameter (F Drill)
Thru both tubes
2 places
2 3
Flush against bearing
1
Figure 10-1