AEQ
PHOENIX ALIO
65
•
Verify that the "SYNC" LED beneath the "CALL" button corresponding to that channel
is lighted in green to indicate that the communication has been successfully
established.
•
Send audio from one equipment to another verifying that the "Tx" and "Rx"
audio presence indicators change to green.
•
If the unit is registering in SIP server and the call is being made but no audio comes
through, please check "NAT TRAVERSAL" configuration (see section 4.3).
6.5.2.1. Ending an IP call in PROXY SIP mode.
•
In order to hang call, just click on "CALL" button corresponding to that channel in one of
both codecs’ individual control window. A confirmation message will appear and the call
will be disconnected after acceptance.
6.5.2.2. Receiving and accepting an IP call in PROXY SIP mode.
If the IP interface is correctly configured and automatic answer mode is OFF, when you receive
a call:
•
The unit and the application will provide acoustic warning. This can be disabled (for the
unit) at "Configuration"
"Miscellaneous"
"Buzzer and test".
•
The "CALL" button red LED corresponding to that channel at the individual codec
control window in the remote control software corresponding to the unit that is receiving
a call will blink at the same time to warn the user.
•
In addition, if "Autoanswer" option is not active, an incoming call window will appear
showing the URI identifier of the caller unit:
•
The call will be accepted by clicking on the individual codec control window "CALL"
button corresponding to that channel or alternatively on the "Accept" button in the
incoming calls window.
•
The screen will show the status of the call:
o
CONNECTING
o
SYNCHRONIZING
o
CONNECTED [-NO_SYNC / -NO_DATA]
•
Verify that the "SYNC" LED beneath the "CALL" button corresponding to that channel is
lighted in green to indicate that the communication has been successfully established.
•
Once connected to the remote end, verify that the "Tx" and "Rx" audio presence
indicators change to green.