Advantech ASR-5300I Series, Руководство пользователя

Страница: 26 / 122

ASR-5300I Series Hardware User Manual 16
2.1 Introduction
This chapter describes how to install modular components; for example, hard drives
into the enclosure, and CBM into the RAID controller enclosure.
2.2 Installation Prerequisites
Static-Free Installation Environment
The system must be installed in a static-free environment to minimize the possibility
of electrostatic discharge (ESD) damage.
Component Check
Before installing the system, check that all the required components are present
using the Unpacking List included in the package. If item(s) are missing or appear
damaged, contact your vendor for a replacement.
Hard Drives
SAS/SATA hard drives must be purchased separately and available prior to system
installation.
Cabling
All the cables that connect the system to the hosts must be purchased separately.
Please refer to System Connection for sample topologies and configuration options.
Contact your vendor for a list of compatible cables.
Memory Modules
For users wishing to change the pre-installed DIMM module, information regarding
the DIMM replacement procedures can be found in Replacing the Memory Module
for RAID Models.
CBM
For single-controller RAID systems, if you ordered a CBM as an additional compo-
nent and wish to install a CBM (BBU and/or FBM), the CBM should be installed prior
to powering on the system.
Rack Installation
The rack slide rails are optional accessories. For information regarding installation,
please refer to the Slide Rail Installation Guide section.
Users should familiarize themselves with the related positions of each plug-in module
and interface connector. Cables must be handled with care and not bent. To prevent
emission interference within a rack system and accidental cable disconnection, the
routing paths should be carefully planned.
Note! Installation into a rack or cabinet should occur BEFORE hard drives are
installed into the system.