ADEMCO VIDEO RapidView, Руководство по эксплуатации

Страница: 30 / 55

Operation Guide Rapid View
© Ademco Video 2002 MNRDVO250602US Page 24
Chapter 5
Using the ’NUMBER’ buttons, select the sector zone (1 to 16)
that you wish to enter a label for.
Note: If an illegal camera number, preset or sector number
is selected, i.e. a camera number higher than the
total cameras on the system, a preset above 127 or a
sector zone higher than 16, then the warning mes-
sage ‘ILLEGAL CAMERA NUMBER’,
‘ILLEGAL PRESET NUMBER’ or ’ILLEGAL
SECTOR NUMBER’ will be flashed at the bottom of
the screen. This will temporarily overwrite the
‘LOCK TO END’ line. (Rather than appearing
beneath it.)
When the camera number, preset or sector zone to be edited is
selected, the letter ‘A’ in the selection of characters will be
flashing, as will the whole of the camera or preset ident being
changed.
Use the joystick to move the flashing area of the character
selection section to the character required. (To enter a space,
select the space after the letter ‘Z’.)
To select the flashing character, press the ‘AUX’ button.
Note: The ident is completely removed if the space
character is selected as the first character.
Press the ‘LOCK’ button when programming of the ident is
complete.
Use the joystick to select another ident to edit or if no item is to
be selected, or set-up of idents has been completed, press the
‘LOCK’ button to return to the main menu. Then press ‘LOCK’
again to return the RapidView to normal operation.
Note: The Preset ident is displayed during a tour, but not
when seeking a preset.